Before you start-
- Install in a clean, shaded area away from wind and dust.
- Thoroughly clean the inside of the glass.
- Make sure all dirt, lint, hair, and residue are removed.
Installation-
1. Identify the correct pre-cut piece for the window.
2. Spray the inside of the glass generously with slip solution.
3. Carefully peel away the clear protective liner from the tint. As you remove the liner, generously spray the exposed adhesive side of the tint with slip solution.
4. Place the wet adhesive side against the inside of the glass.
5. Slide the film into position and line up the edges.
6. Once positioned correctly, spray slip solution again (DO NOT SQUEEGEE DRY). Use your squeegee to push the solution and air out from underneath the film.
7. Check the edges and make sure the film is lying properly.
After Installation:
Allow the tint time to completely dry. A hazy appearance or small moisture pockets can occur while the film is curing. If possible, park directly in the sun.
Do not roll the windows down for 3-5 days after installation to allow the film to properly cure.
Need Help?
If you have questions during installation, visit our Contact page and we'll be happy to help.